| Function Modes: | Clean (spin, high pressure spray) |
| Dry (spin, heat and N2 | |
| Function Duration: | Clean (from 1 to 180 seconds) |
| Dry (from 1 to 180 seconds) | |
| Chuck speed: | 2,000 RPM during wash and dry cycles |
| Water Requirement: (Typically DI) | 20 to 70 psi |
| Cleaning pressure: | Up to 3,000 psi maximum |
| (typically run at 1,800 - 2,000 psi) | |
| Air requirement: | Compressed air or nitrogen |
| 85 to 100 psi, 7 cfm | |
| * Steady volume very critical | |
| Drain requirement: | 3/4" OD barb fitting with 5' length of 3/4" ID |
| 1.0" OD Tygon tubing provided | |
| 1/4" ID hose from pump assembly for valve water dump | |
| Power requirement: | Standard - 115 VAC, 5 amps, 50/60 Hz |
| Optional - 220 VAC, 2.5 amps, 50/60 Hz | |
| N2 requirement: | 10-40 psi filtered (for N2 blow-off during DRY cycle) |
| Exhaust: | 3" exhaust port plus a 5' length of flexible PVC hose |
| (3" ID) provided | |
| 100-150 CFM, typical, recommended | |
|
spec2066
|